Suitable for insulating, sealing and filling of seams, joints, gaps, holes and cracks in wall partitions, window and door frames, roof boards, chimneys, dormers and penetrations of pipes, tubes, cables and power lines. Bonds to many building materials, such as wood, concrete, stone, masonry, plasterwork, metal, glass and many synthetics, including polystyrene, polyester and PVC.

Not suitable for bitumen, silicone, polyethylene (PE), polypropylene (PP) and P.T.F.E.

Only apply at temperatures between +5°C and +40°C.

The substrate must be thoroughly clean and free of grease. Slightly moisten dry surfaces.

PU-Foam Gun

Shake well before use (10-20 times).

Mount the aerosol on the PU Foam gun. By pulling the trigger, the foam can be dosed easily and precisely. Hold the can upside down while spraying. Fill the area for about 65%. For filling large volumes apply foam in layers and allow to fully froth. Moisten between each layer. After curing, the foam can be cut, drilled and painted, and, if desired, plastered. After use, clean the gun with GRIFFON PU cleaner.

Wear gloves and safety goggles and provide adequate ventilation.

Remove wet stains immediately with GRIFFON PU-Foam Cleaner or acetone. Cured stains can only be removed mechanically.

Store upright in properly sealed packaging in a dry place between +5°C and +25°C.