Skip to content

Bison Kit® / Contact Kit

EAN: 8710439040264Article No.: 1301190
Aromatic-free, universal, liquid contact adhesive based on neoprene rubber.
  • Bonds immediately
  • Heat resistant up to + 70°C
  • Good workability
  • Aromatics-free
  • Universal
  • Liquid
  • Moisture resistant
  • Frost resistant

Properties

  • Bonds immediately
  • Heat resistant up to + 70°C
  • Good workability
  • Aromatics-free
  • Universal
  • Liquid
  • Moisture resistant
  • Frost resistant

Application

Suitable for:

For surface bonding or laminating many materials that need to be bonded, submitted to a load and/or treated immediately. Ideal for materials under pressure or curved work, whereby it is impossible to clamp or press. Surfaces to be bonded need to fit completely. Highly suitable for bonding and laminating of metal and hard synthetic panel boards (HPL; Formica, Duropal, Resopal), veneer, hardboard and plywood on, for example, wood, multiplex plywood, chipboard or MDF. Also for bonding flexible insulation and foam materials, cork, leather and rubber.

Not suitable for:

Not suitable for PE, PP, PTFE and polystyrene foam (isomo).

Handling

Before use

Working conditions

Only use at temperatures between +15°C and +25°C and with maximum relative humidity of 65%. In order to prevent the formation of bubbles due to condensation, the temperature of the adhesive and materials to be bonded should be the same as the ambient temperature and preferably between +18°C and +20°C. Never allow a draught onto pasted surfaces.

Surface requirements

Surfaces must be dry, clean, dust- and grease-free and a good fit.

Preliminary surface treatment

Clean and degrease the surfaces to be glued using Griffon Reiniger. Highly absorbent surfaces should be primed first with diluted Contact Kit (add 10-20% Griffon Cleaner)

Tools

Fine-toothed (1 mm) adhesive spreader, brush, rubber hammer, pressure roller or press.

Preparation of product

Stir well before use. If necessary, dilute to original viscosity.

Coverage

2-2.5 m²/litre, applied on both sides, depending on the nature of the materials to be bonded.

During use

Directions For Use

Apply the adhesive thinly and evenly to both surfaces using the fine-toothed adhesive spreader (1 mm) or brush. Allow both parts to dry for 10 to 40 minutes. As soon as the adhesive stops stringing, join parts. Adjustment is then no longer possible. Avoid trapping air bubbles. Firmly tap, roll or press materials.

Points of attention

If the adhesive joint on porous materials comes into sustained contact with water, the adhesive can become detached from the surface.

After use

Stains/residue

Wet adhesive residue can be removed using Griffon Cleaner. Dried adhesive residue can be removed mechanically or by using a paint stripper.

Storage conditions

Close container properly and store in a dry, cool and frost-free place.

Documents

Similar products