Description
Properties
- Very fast (firm to touch in 30 minutes)
- Extremely high final bond strength (110 kg/cm²)
- Waterproof (D4)
- PU & Solvent free
- Very good filling capacity (up to 4 mm)
- Can be scraped immediately
- Permanently flexible
- Paintable
- All-weather resistant
- UV resistant
- Thixotropic
- Good standing power; does not drip
- ATG certified (Cert. no. ATG 3125) ‘Adhesives for non-supporting wooden structures’
- KOMO certified (Cert. no. 32394) ‘Adhesives for non-supporting applications’
- Innovative formula: patent pending
Applications
Suitable for:
- For waterproof (D4) (surface) bonding of most types of wood (less suitable for chemically treated wood) and many other building materials. For non-supporting wooden structures. Very suitable for poorly fitting joints. Not suitable for PE, PP, PFTE and PA (nylon).
- D4: Interiors where flowing water or condensation are present over long periods on a regular basis. Exteriors exposed to the influences of the weather, providing effective protection for bonded wood.
Handling
Before use:
Working conditions
The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C. Wood humidity must preferably be between 10% and 18% (max. 25%).
Surface requirements
Surfaces must be clean, dust- and grease-free. Degrease oily types of wood with Griffon Cleaner. Roughen non-porous materials.
Preliminary surface treatment
Surfaces must be clean, dust- and grease-free. Degrease oily types of wood with Griffon Cleaner. Roughen non-porous materials.
Tools
Sealant gun, glue spreader, brush or roller.
During use:
Directions for use
Apply the adhesive evenly directly from cartridge on both sides (for the best result) with a sealant gun. Where needed spread further with sealant gun, glue spreader, brush or roller. Ensure adequate layer thickness. Assemble joint within 5 minutes and fixate for at least 30 min. No pressing. If clamped, use a limited pressure to avoid too much adhesive to be pushed out of the bond.
After use:
Stains/residue
Remove wet adhesive residue immediately with Griffon Cleaner. Dry adhesive residue can only be removed mechanically.
Storage conditions
Store in properly sealed packaging in a dry place at between +5°C and +25°C.