Poly Max® High Tack Express

Cartridge 435 g White

Solvent-free assembly adhesive with very high initial bond strength.

Poly Max® High Tack Express

Description

Properties

  • Very high initial bond strength
  • Very fast strength gain
  • Permanently elastic
  • Very good filling capacity
  • Good standing power
  • Non-shrinking; 100% adhesive
  • Solvent-free
  • No soiling of joint edges
  • All-weather resistant
  • Resistant to temperatures between -40°C and +100°C
  • Paintable
  • Curing ca. 2 mm/24 hours

APPROVALS

  • 48_2.png
  • 48_5.png
  • 48_3.png
  • 48_1.png
  • 48_4.png
Go to top

Applications

Suitable for:

For bonding and fixing many construction materials on practically all surfaces, such as wood, plaster, (natural) stone, (cellular) concrete, metal, hard foam and various plastics. Drywall construction: Bonding/fixing of UW rails in floor, ceiling and wall areas. Suitable for internal and external applications, such as panels, ceiling elements, roof fascias, plasterboard, panelling and insulation material, mirrors, timber framework, skirting boards and laths. For all professional applications including wall and interior construction, house, utility and bodywork building.

Not suitable for:

Not suitable for PE, PP, PTFE, gypsum and bitumen. When gluing plastics always perform an adhesion test first. Adhesion to plastics can vary depending on the type of synthetic and the quality of the plastic.

Go to top

Handling

Before use:

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should be no less than +5°C.

Surface requirements

Surfaces must be clean, dust- and grease-free. Surface must be solid. The surface may be slightly moist. Use of primer not required.

Tools

Sealant gun and rubber hammer.

Preparation of product

Before using open cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Then fix the nozzle and cut at an angle (opening at least Ø 5 mm).

Coverage

One cartridge issues approx. 7-9 metres of adhesive.

During use:

Handling of packaging

Only apply with special nozzle supplied.

Directions for use

Depending on the weight of the material, apply the adhesive evenly in vertical strips or dots at intervals of between 10 and 40 cm. Always apply adhesive to the corners and along the edges. Mutual moving of materials (facade panels) can be accommodated through an adhesive thickness of 3 mm (use spacer blocks, or tape). Assemble materials with a sliding movement and press or hammer firmly together. Correction is still possible. Close the cartridge properly immediately after use.

Points of attention

The following drying times are based on bonding at least one porous material and an adhesive layer of approx. 1 mm thickness. If two non-porous materials are being bonded and/or the layer of adhesive is thicker, the drying times may be substantially longer.

After use:

Stains/residue

Remove adhesive residues immediately with white spirit. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store dry in sealed packaging between +5°C and +25°C.

Go to top

Related products

Go to top