- For internal and external use (EN 204 D4)
- Transparent when dry
For waterproof (D4) joining and laminating of practically all soft, hard and exotic types of woods. Suitable for well-fitting, non-bearing wood structures using various finger joints, dovetails, mortise and tenon joints, dowels and springs. Suitable for interior and exterior applications including frames, windows, doors, fencing and furniture. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface. D4: Interiors where flowing water or condensation are present over long periods on a regular basis. Exteriors exposed to the influences of the weather, providing effective protection for bonded wood.
The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C. Relative air humidity of up to 65%. The moisture content of the wood should be between 8% and 16%.
Surfaces must be clean, dust and grease-free and a good fit.
Preliminary surface treatment
Degrease oily types of wood with an appropriate cleaner.
Fine-toothed adhesive spreader (1 mm), brush or roller, clamps or press.
Preparation of product
Stir well before use.
Dilute only with water.
5-7 m²/kg, applied on both sides, depending on the nature of the materials.
Directions for use
Apply the adhesive thinly and evenly on one or both parts using a fine-toothed adhesive spreader (1 mm), brush or roller. Allow the adhesive to soak in for a couple of minutes. Assemble joint within 8 minutes then clamp or press.
Points of attention
Avoid corrosion on metal parts (e.g. pump or machinery components). Use only acid resistant components with mechanical processing.
Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.
Store in properly sealed packaging in a dry place at between +10°C and +20°C.