Skip to content

Wood Adhesive PVACST10 (D2)

EAN: 8710439177670Article No.: 6306021
Moisture resistant (EN 204 D4), white wood adhesive based on PVAC.
  • For internal use (EN 204 D2)
  • Moisture resistant
  • Transparent when dry
  • Solvent-free
  • Paintable


  • For internal use (EN 204 D2)
  • Moisture resistant
  • Transparent when dry
  • Solvent-free
  • Paintable


Suitable for:

For water-resistent (D2) joining and laminating of practically all soft, hard and exotic types of wood. Suitable for well-fitting, non-load bearing wooden structures using various wood joints such as finger joints, dovetail joints, mortise and tenon joints, dowels and springs. Suitable for indoor applications such as doors and furniture in, for example, living rooms and offices. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface. D2: Interior spaces in which increased relative humidity occurs occasionally and for a short time, whereby the level of wood humidity remains below 18%.


Before use

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C. Relative humidity of up to 65%. Level of wood humidity between 8% and 12%.

Surface requirements

Surfaces must be clean, dust and grease-free and a good fit.

Preliminary surface treatment

Degrease oily types of wood with an appropriate cleaner.


Fine-toothed adhesive spreader (1 mm), brush or roller, clamps or press.


Dilute only with water.


5-7 m²/kg, applied on both sides, depending on the nature of the materials.

During use

Directions For Use

Apply the adhesive thinly and evenly on one or both parts using a fine-toothed adhesive spreader (1 mm), brush or roller. Allow the adhesive to soak in for a couple of minutes. Assemble joint within 8 minutes then clamp or press.

Points of attention

Avoid corrosion on metal parts (e.g. pump or machinery components). Use only acid resistant components with mechanical processing.

After use


Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +10°C and +20°C.


Approval marks & standards

Similar products