Silicone Sanitaire S-100

Cartridge 300 ml Transparent

Water-resistant silicone sealant for all sanitary sealings

Silicone Sanitaire S-100

Description

Properties

  • Very fast curing
  • Easy to apply
  • Mould resistant
  • Permanently elastic
  • Colourfast
  • Water resistant
  • UV resistant
  • Resistant to cleaning agents

APPROVALS

  • 48_1.png
Go to top

Applications

Suitable for:

Suitable for sealing seams, joints and gaps, e.g., in bathrooms, showers, toilets and kitchens. Bonds, among other things, to (glazed) tiles, enamel, ceramics, various metals (aluminium / stainless steel) and glass. Not suitable for acrylic, PVC, marble, natural stone, bitumen, PE, PP, PTFE. In acrylic bathtubs, synthetic shower bases and shower walls use Griffon Silicone Sealant S-200.

Go to top

Handling

Before use:

Working conditions

Only apply at temperatures between +5°C and +40°C.

Surface requirements

The surface must be dry, clean and free of dust, rust, paint and grease. Prime synthetics with Silicon Primer. Synthetics must first be roughened.

Preliminary surface treatment

For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.

During use:

Handling of packaging

Use sealant gun to handle cartridge. Open the cartridge by cutting off the plastic nipple on the top side at the screw thread with a sharp knife. Screw on the nozzle and chamfer at the desired width.

Directions for use

Ensure a minimum joint width of 6 mm and a maximum of 20 mm. The joint depth depends on the joint width. Keep a joint depth of 6 mm up to a joint width of 12 mm. Beyond that, the joint depth should be half the joint width. Apply the sealant evenly and smooth it within 10 minutes with a mild soap solution (use Griffon Silicone Finish and Multi-tool). Remove the applied masking tape immediately after tooling. After approx. 15 minutes, a surface skin will form. Cured silicone sealant can only be removed mechanically.

Advice

In acrylic bathtubs, synthetic shower bases and shower walls use Griffon Silicone Sealant S-200.

Points of attention

Silicone hardens under the influence of humidity. Contact with humidity is therefore absolutely necessary during curing. Alijd consider a joint of at least 6 mm wide. By applying masking tape along the joints completely smooth seams are achieved, remove the tape immediately after smoothing. The sealant is loadable with water after 2 hours; however, do not touch or load mechanically.

After use:

Stains/residue

Immediately remove stains with white spirit. The cured sealant can be removed either mechanically or with Griffon silicone sealant residue remover.

Storage conditions

Store in properly sealed packaging in a dry place at between +5°C and +25°C.

Go to top