Wood Adhesive KM45®

Flacon  750 g

Waterproof 1-component PVAc wood glue

Wood Adhesive KM45®



  • For internal and external use
  • Waterproof
  • Transparent when dry
  • Solvent-free
  • Paintable


  • 48_1.png
  • 48_2.png
Go to top


Suitable for:

  • For waterproof (D4) joining and laminating of practically all soft, hard and exotic types of woods. Suitable for well-fitting, non-bearing wood structures using various finger joints, dovetails, mortise and tenon joints, dowels and springs.
  • Suitable for interior and exterior applications including frames, windows, doors, fencing and furniture. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface.
  • D4: Interiors where flowing water or condensation are present over long periods on a regular basis. Exteriors exposed to the influences of the weather, providing effective protection for bonded wood.
Go to top


Before use:

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C. Relative air humidity of up to 65%. The moisture content of the wood should be between 8% and 16%.

Preliminary surface treatment

Surfaces must be clean, dust and grease-free and a good fit. Degrease oily types of wood with Griffon Cleaner.


Fine-toothed adhesive spreader (1 mm), brush, roller or adhesive injection equipment, clamps or press.

Preparation of product

Stir well before use.

During use:

Directions for use

Apply the adhesive thinly and evenly on one or both parts using a fine-toothed adhesive spreader (1 mm), brush, roller or pneumatic adhesive injection equipment. Allow the adhesive to soak in for a couple of minutes. Assemble joint within 8 minutes then clamp or press.

Points of attention

Avoid corrosion on metal parts (e.g. pump or machinery components). Use only acid resistant components with mechanical processing.

After use:


Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +10°C and +20°C.

Go to top

Related products

Go to top