Skip to content

Wood Max Power

EAN: 8710439277004Article No.: 6313838
Extremely strong, waterproof, di-isocyanate free and filling wood construction adhesive based on SMP-Polymer.
  • Extremely high final bond strength (110 kg/cm²)
  • Waterproof (D4)
  • PU & Solvent free
  • Very good filling capacity (up to 4 mm)
  • Can be scraped immediately
  • Permanently flexible
  • Paintable
  • All-weather resistant
  • UV resistant
  • Thixotropic
  • Good standing power; does not drip
  • Innovative formula: patent pending

Properties

  • Extremely high final bond strength (110 kg/cm²)
  • Waterproof (D4)
  • PU & Solvent free
  • Very good filling capacity (up to 4 mm)
  • Can be scraped immediately
  • Permanently flexible
  • Paintable
  • All-weather resistant
  • UV resistant
  • Thixotropic
  • Good standing power; does not drip
  • Innovative formula: patent pending

Application

Suitable for:

For waterproof (D4) (surface) bonding of practically all types of wood as well as bonding practically all types of wood to many building materials, such as gypsum, (natural) stone, (cellular) concrete, metal, hard foam and various synthetics. Suitable for non-load bearing wooden structures using various wood joints such as mortise and tenon joints, dowels and springs. Suitable for interior and exterior applications, such as façade carpentry and sandwich panels. Very suitable for less-fitting joints (for example, unplaned wood). Ideal for both vertical and horizontal applications. D4: Interiors where flowing water or condensation are present over long periods on a regular basis. Exteriors exposed to the influences of the weather, providing effective protection for bonded wood. ISO 9142 (laboratory ageing conditions under which adhesive joints may be exposed to various environmental influences – climatic or chemical): Wood Max Power exposed to salt (sea) water.

Not suitable for:

Not suitable for PE (polyethylene), PP (polypropylene) and PTFE

Handling

Before use

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C. Wood humidity must preferably be between 10% and 18% (max. 25%).

Surface requirements

Surfaces must be clean, dust- and grease-free.

Preliminary surface treatment

Degrease oily types of wood with Griffon Cleaner. Roughen non-porous materials.

Tools

Sealant gun, fine-toothed glue spreader (1 mm), brush, roller, clamp.

Coverage

With spot bonding: 5-8 m²/kg. Stripes: one cartridge issues approx. 8-15 metres of adhesive (nozzle opening 3 mm = ±15 metres – nozzle opening 5 mm = ±8 metres).

During use

Directions For Use

Apply the adhesive evenly directly from cartridge on one or both sides (depending on application) with a sealant gun. Where needed spread further with sealant gun, glue spreader, brush or roller. Ensure adequate layer thickness. Assemble joint within 30 minutes and fixate for at least 6 hours. Pressing or clamping is not necessary. If pressed or clamped, use a limited pressure to avoid too much adhesive to be pushed out of the bond.

After use

Stains/residue

Remove wet adhesive residue immediately with Griffon Cleaner. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +5°C and +25°C.

Documents

Approval marks & standards

Videos

Similar products