Skip to content

IPS-300

EAN: 8710439298740Article No.: 7000573
Treated surface becomes water and dirt proof, does not change colour and remains vapor permeable.Provides 10 years protection against rain penetration and pollution, improves the insulation capacity, which leads to energy savings.
  • Water- and dirt proof Vapour permeable UV resistant Doesn’t affect surface colour Hydrophobic technology Durable effect: 10 years protection

Properties

  • Water- and dirt proof
  • Vapour permeable
  • UV resistant
  • Doesn’t affect surface colour
  • Hydrophobic technology
  • Durable effect: 10 years protection

Application

Suitable for:

For absorbent and porous, mineral surfaces such as facades, masonry, paving, terraces and pool copings (brick, concrete, sand-lime brick, sandstone, limestone, porous natural stone and tiles)

Handling

Before use

Working conditions

Use at temperatures between +5 °C and +35 °C. Upon application, the surface temperature should not exceed 40°C. Do not apply if rain is expected within 4 hours.

Surface requirements

Not suitable for non porous mineral surfaces. Always try beforehand on a small (preferably non visible) place.

Tools

Pressure sprayer

Dilute

Do not dilute.

Coverage

5 liter of IPS-300® is sufficient for approximately 13 - 17 m² of surface applied in 2 layers (wet on wet). Actual consumption depends on porousness of the surface, application method, experience and weather influences.

During use

Directions For Use

Always check porousness of the surface in advance! Clean surface from dirt, dust, oil, old paint, efflorescence and organic growth. If a green algae remover, acid or alkaline cleaning agent has been used, rinse the surface well with water. Surface has to be complete dry before application. Mask surfaces which will not be treated, such as window frames, windows and plants. Do not apply if rain is expected within 4 hours. Shake jerrycan before filling pressure sprayer. Do not dilute IPS-300®. Spray in small sections of 1-2m² – apply from top to bottom – at an approximate 20 cm distance from the surface. Always apply second layer ‘wet on wet’ – within 10 minutes of previous application. Once treated surface is dry, it’s not possible to apply an additional layer. IPS-300® may also be applied with brush or roller in case of small surfaces. Use water to clean tools afterwards. The surface is water and dirt repellant after 12 hours – maximum protection after 7 days.

Advice

If medical advice is needed, have product container or label at hand.

Points of attention

Always try beforehand on a small (preferably non visible) place. Risk of corrosion: protect material in the vicinity, such as window frames, windows and plants. If applied in excess, a white deposit may form (after drying), which is difficult to remove.

Personal Safety

Wear protective gloves / protective clothing / eye protection / face protection

After use

Stains/residue

Fresh residue - wipe off any fresh residue before the product dries and clean with water. In case a white slayer appears after 24 hours, this can only be removed mechanically. Use a fine abrasive pad/ scrub pad which can be used on an electric drill to remove white stains carefully.

Storage conditions

Store in a dry place in a sealed packaging, at a temperature between +5 °C and +25 °C. Best before date (MM/YY): see package.

Documents

Approval marks & standards

Similar products