For mounting many building materials such as wood, plaster, (natural) stone, (gas) concrete, metal, rigid foam, various plastics, sheet and insulation materials, roof plates and cover profiles.

Not suitable for PE, PP en (PA) (nylon).

The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C.

Surfaces must be clean, dust- and grease-free. Degrease oily materials with Griffon Cleaner. Roughen non-porous materials.

Surfaces must be clean, dust- and grease-free. Degrease oily materials with Griffon Cleaner. Roughen non-porous materials.

Apply the adhesive evenly directly from cartridge on both sides (for the best result) with a sealant gun. Where needed spread further with glue spreader. Ensure adequate layer thickness. Assemble joint within 5 minutes and fixate for at least 30 min. No pressing. If clamped, use a limited pressure to avoid too much adhesive to be pushed out of the bond.

Remove wet adhesive residue immediately with Griffon Cleaner. Dry adhesive residue can only be removed mechanically.

Store in properly sealed packaging in a dry place at between +5°C and +25°C.