Silicone Sanitaire S-200

Cartridge white 300 ml

High-quality, neutral, permanently elastic, water resistant sanitary silicone sealant.

Silicone Sanitaire S-200



  • Very fast curing
  • Easy to apply
  • 100% silicone
  • Neutral, acid-free
  • Odourless
  • Mould resistant
  • Permanently elastic
  • Water resistant
  • Resistant to cleaning agents
  • Colourfast
  • UV resistant


  • 48_2.png
  • 48_1.png
Go to top


Suitable for:

Suitable for sealing seams, joints and gaps, e.g., in bathrooms, showers, toilets and kitchens. Ideal for acrylic bathtubs, synthetic shower bases and shower walls. Bonds, among other things, to synthetics (acrylic/PVC), (glazed) tiles, enamel, ceramics, various metals (aluminium / stainless steel) and glass. Not suitable for bitumen, PE, PP or PTFE.

Not suitable for:

Not suitable for polyethylene (PE), polypropylene (PP), PTFE and bitumen.

Go to top


Before use:

Working conditions

Only apply at temperatures between +5°C and +40°C.

Surface requirements

The substrate must be properly dry, clean and free of dust and grease. Remove any existing sealant residue.

Preliminary surface treatment

For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.


Content suitable for approx. 8 to 15 m (depending on the diameter of the joint).

During use:

Handling of packaging

Use sealant gun to handle cartridge. Open the cartridge by cutting off the plastic nipple on the top side at the screw thread with a sharp knife. Screw on the nozzle and chamfer at the desired width.

Directions for use

Ensure a minimum joint width of 6 mm and a maximum of 20 mm. The joint depth depends on the joint width. Keep a joint depth of 6 mm up to a joint width of 12 mm. Beyond that, the joint depth should be half the joint width. Apply the sealant evenly and smooth it within 10 minutes with a mild soap solution (use GRIFFON Silicone Finish and Multi-tool). Remove the applied masking tape immediately after tooling. After approx. 15 minutes, a surface skin will form. Cured silicone sealant can only be removed mechanically.

Points of attention

Silicone hardens under the influence of humidity. Contact with humidity is therefore absolutely necessary during curing. Alijd consider a joint of at least 6 mm wide. By applying masking tape along the joints completely smooth seams are achieved, remove the tape immediately after smoothing. The sealant is loadable with water after 2 hours; however, do not touch or load mechanically.

After use:


Immediately remove stains with white spirit. The cured sealant can be removed either mechanically or with GRIFFON silicone sealant residue remover.

Storage conditions

Store in properly sealed packaging in a dry place at between +5°C and +25°C.

Go to top

Related products

Go to top