Skip to content

Poly Max® High Tack

EAN: 8710439042015Article No.: 1490909
Solvent-free assembly adhesive with very high initial bond strength based on SMP-Polymer. Excellent for heavy materials.
  • Very high initial bond strength
  • Permanently elastic
  • Very good filling capacity
  • Good standing power
  • Non-shrinking; 100% adhesive
  • Solvent-free
  • No soiling of joint edges
  • All-weather resistant
  • Resistant to temperatures between -40°C and +100°C
  • Paintable
  • Curing ca. 2 mm/24 hours

Properties

  • Very high initial bond strength
  • Permanently elastic
  • Very good filling capacity
  • Good standing power
  • Non-shrinking, 100% adhesive
  • Solvent-free
  • No soiling of joint edges
  • All-weather resistant
  • Resistant to temperatures between -40°C and +100°C
  • Paintable
  • Curing ca. 2 mm/24 hours

Application

Suitable for:

For bonding and fixing many construction materials on practically all surfaces, such as wood, plaster, (natural) stone, (cellular) concrete, metal, hard foam and various plastics. Suitable for internal and external applications, such as panels, ceiling elements, roof fascias, panelling and insulation material, mirrors, timber framework, skirting boards and laths. For all professional applications including wall and interior construction, house, utility and bodywork building.

Not suitable for:

Not suitable for PE, PP, PTFE, pure plaster and bitumen. When gluing plastics always perform an adhesion test first. Adhesion to plastics can vary depending on the type of synthetic and the quality of the plastic.

Handling

Before use

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should be no less than +5°C.

Surface requirements

Surfaces must be clean, dust- and grease-free. Surface must be solid. The surface may be slightly moist. Use of primer not required.

Tools

Cartridge gun and rubber hammer.

Preparation of product

Before using open cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Then fix the nozzle and cut at an angle (opening at least Ø 5 mm).

Coverage

One cartridge issues approx. 5-6 metres of adhesive.

During use

Handling Of Packaging

Only apply with special nozzle supplied.

Directions For Use

Cut the thread and assemble the nozzle. Depending on the weight of the material, apply the adhesive evenly in vertical strips or dots at intervals of between 10 and 40 cm. Always apply adhesive to the corners and along the edges. Mutual moving of materials (facade panels) can be accommodated through an adhesive thickness of 3 mm (use spacer blocks, or tape). Assemble materials with a pushing movement and press or knock firmly together. Correction is still possible. Close the cartridge properly immediately after use.

Points of attention

The following drying times are based on bonding at least one porous material and an adhesive layer of approx. 1 mm thickness. If two non-porous materials are being bonded and/or the layer of adhesive is thicker, the drying times may be substantially longer. Avoid lasting direct contact with UV radiation (eg. sealing applications outdoors).

After use

Stains/residue

Remove adhesive residues immediately with white spirit. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store dry in sealed packaging between +5°C and +25°C.

Documents

Approval marks & standards

Similar products

Accessoires