Skip to content

Wood Adhesive PVAc KM45 (D4)

EAN: 8710439042039Article No.: 1339410
Waterproof (EN 204 D4), white, single-component wood adhesive based on PVAC.
  • For internal and external use (EN 204 D4)
  • Waterproof
  • Transparent when dry
  • Solvent-free
  • Paintable

Properties

  • For internal and external use (EN 204 D4)
  • Waterproof
  • Transparent when dry
  • Solvent-free
  • Paintable

Application

Suitable for:

For waterproof (D4) joining and laminating of practically all soft, hard and exotic types of woods. Suitable for well-fitting, non-bearing wood structures using various finger joints, dovetails, mortise and tenon joints, dowels and springs. Suitable for interior and exterior applications including frames, windows, doors, fencing and furniture. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface. D4: Interiors where flowing water or condensation are present over long periods on a regular basis. Exteriors exposed to the influences of the weather, providing effective protection for bonded wood.

Handling

Before use

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C. Relative air humidity of up to 65%. The moisture content of the wood should be between 8% and 16%.

Surface requirements

Surfaces must be clean, dust and grease-free and a good fit.

Preliminary surface treatment

Degrease oily types of wood with an appropriate cleaner.

Tools

Fine-toothed adhesive spreader (1 mm), brush, roller or adhesive injection equipment, clamps or press.

Preparation of product

Stir well before use.

Dilute

Dilute only with water.

Coverage

5-7 m²/kg, applied on both sides, depending on the nature of the materials.

During use

Directions For Use

Apply the adhesive thinly and evenly on one or both parts using a fine-toothed adhesive spreader (1 mm), brush, roller or pneumatic adhesive injection equipment. Allow the adhesive to soak in for a couple of minutes. Assemble joint within 8 minutes then clamp or press.

Points of attention

Avoid corrosion on metal parts (e.g. pump or machinery components). Use only acid resistant components with mechanical processing.

After use

Stains/residue

Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +10°C and +20°C.

Documents

Approval marks & standards

Similar products