Description
Go to topApplications
Suitable for:
- For mounting many building materials such as wood, plaster, (natural) stone, (gas) concrete, metal, rigid foam, various plastics, sheet and insulation
- materials, roof plates and cover profiles.
Not suitable for:
Not suitable for PE, PP en (PA) (nylon).
Handling
Before use:
Working conditions
The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C.
Surface requirements
Surfaces must be clean, dust- and grease-free. Degrease oily materials with Griffon Cleaner. Roughen non-porous materials.
Preliminary surface treatment
Surfaces must be clean, dust- and grease-free. Degrease oily materials with Griffon Cleaner. Roughen non-porous materials.
During use:
Directions for use
Apply the adhesive evenly directly from cartridge on both sides (for the best result) with a sealant gun. Where needed spread further with glue spreader. Ensure adequate layer thickness. Assemble joint within 5 minutes and fixate for at least 30 min. No pressing. If clamped, use a limited pressure to avoid too much adhesive to be pushed out of the bond.
After use:
Stains/residue
Remove wet adhesive residue immediately with Griffon Cleaner. Dry adhesive residue can only be removed mechanically.
Storage conditions
Store in properly sealed packaging in a dry place at between +5°C and +25°C.
